0769-23388351
Toggle Navigation
In some common DC motors, there are two kinds of magnet steels that are used most, namely tile arc magnet and straight plate (rectangular) magnet. Some netizens will ask, what is the biggest difference between the two? Which is better?
The biggest difference between arc magnet and rectangular magnet
Arc shaped magnetic steel has better air tightness and higher efficiency. The biggest difference between the tile and the straight plate is that the tile can reduce the pole pairs when the air gap is constant, so as to improve the efficiency of the motor at high speed. Because the magnetizing surface of the straight plate magnetic steel is always straight, the pole pairs cannot be less than that of the tile magnetic steel when the air gap is constant. However, the electric vehicle motors are all made of silicon steel stator, the higher the working frequency, the greater the iron loss, Tile magnetic steel can solve this problem. After the polar logarithm is reduced, the frequency of silicon steel plate at the same speed will be reduced, and the iron loss will be relatively reduced, and other differences are very small.
Usually, Arc magnetic steel is chosen for high power generators.
The above is the difference between arc segment magnet and rectangular magnet introduced to you by Chinese permanent magnet manufacturer Courage Xiafu. I hope it will be helpful to you. Please contact us if you need to customize motor magnet!
Motor commonly used magnet product recommendation;
This is a very small rectangular ferrite block magnet, measuring 2.45 mm in length and 1 mm in both width and height. It is magnetised along its length and is barely noticeable when held in the hand....
7.4x6x5mm Ferrite Small Block Magnet Introduction，Material: Hard Ferrite (Ceramic)，Shape: Block / Rectangle / Bar，Coating: No Coating，Grade (Chinese Stardard): Y30，Operating temperature: -40°C to 250°C，Delivery time: 7-15 days，Magnetization direction: thickness....
U-shaped neodymium magnets are a type of high-performance permanent magnet material with a structure resembling the letter ‘U’. Manufactured from sintered neodymium-iron-boron, they are characterised by high magnetic energy product....
This is a radial 4-pole ring (Hollow cylinder) magnet, the material is bonded NdFeB, with high magnetic performance, the size is 16mm outer diameter, inner hole 5mm, height 20mm, surface gray epoxy treatment, suitable for water pump motor...
This product is a 4-pole ring magnet, injection-molded ferrite material, the sample size is 22mm outer diameter, 7mm inner diameter, 4mm thickness, 2 N poles and 2 S poles, mainly used for push rod motors, magnetic induction devices, encoders, etc.,...
This is a radial 2 pole circular magnet designed specifically for magnetic encoder chips. It is made of sintered neodymium-iron-boron with N35 grade performance and is suitable for standard environments....
This product is a multi pole magnetic ring with an inner diameter of 1.5mm. The material is injection molded ferrite. It adopts axial multi pole magnetization and is mainly used for DC motors. If you have a sample of similar injection molded magnetic products, please contact us for quotation....
This is a very small size rectangular block magnet with galvanized surface, 3mm length, 1.5mm width and height, with very fine tolerance, magnetized by lengthwise direction, mainly used in precision electronics, instrumentation, please contact us if you need to buy....