0769-23388351
Toggle Navigation
Some netizens asked how the multi-pole magnetic ring on the motor shaft and the shaft are generally fixed together? The following is the introduction of Courage Magnet on this issue.
1. If the magnet is on the stator, use Outai's Braun anaerobic structural glue or ab glue. If the magnet is on the rotor, use modified acrylic glue, and the initial positioning is 5-10 minutes. Full solid 24 hours, all this time.
2. It can be wrapped with nylon fiber first, then coated with epoxy resin, then wrapped with fiber, and then coated until the size is right.
Motor rotor magnetic ring - injected ferrite material
Usually, the gap between the motor shaft and the inner rotor magnetic steel is very small, which requires better control of the inner diameter tolerance of the magnetic ring. challenging.
However, this is not a problem. Our company can customize the motor magnetic ring in strict accordance with customer requirements, control the inner diameter of the magnetic ring to be precise, and ensure that the magnetic ring and the steel shaft can be assembled without problems.
Ring magnet column used on the motor;
Injection Molded Ferrite Magnets
Recommended articles related to content;
This is a very small rectangular ferrite block magnet, measuring 2.45 mm in length and 1 mm in both width and height. It is magnetised along its length and is barely noticeable when held in the hand....
7.4x6x5mm Ferrite Small Block Magnet Introduction，Material: Hard Ferrite (Ceramic)，Shape: Block / Rectangle / Bar，Coating: No Coating，Grade (Chinese Stardard): Y30，Operating temperature: -40°C to 250°C，Delivery time: 7-15 days，Magnetization direction: thickness....
U-shaped neodymium magnets are a type of high-performance permanent magnet material with a structure resembling the letter ‘U’. Manufactured from sintered neodymium-iron-boron, they are characterised by high magnetic energy product....
This is a radial 4-pole ring (Hollow cylinder) magnet, the material is bonded NdFeB, with high magnetic performance, the size is 16mm outer diameter, inner hole 5mm, height 20mm, surface gray epoxy treatment, suitable for water pump motor...
This product is a 4-pole ring magnet, injection-molded ferrite material, the sample size is 22mm outer diameter, 7mm inner diameter, 4mm thickness, 2 N poles and 2 S poles, mainly used for push rod motors, magnetic induction devices, encoders, etc.,...
This is a radial 2 pole circular magnet designed specifically for magnetic encoder chips. It is made of sintered neodymium-iron-boron with N35 grade performance and is suitable for standard environments....
This product is a multi pole magnetic ring with an inner diameter of 1.5mm. The material is injection molded ferrite. It adopts axial multi pole magnetization and is mainly used for DC motors. If you have a sample of similar injection molded magnetic products, please contact us for quotation....
This is a very small size rectangular block magnet with galvanized surface, 3mm length, 1.5mm width and height, with very fine tolerance, magnetized by lengthwise direction, mainly used in precision electronics, instrumentation, please contact us if you need to buy....