0769-23388351
Toggle Navigation
Magnets made of different magnetic materials require different magnetization energy. Compared with ferrite magnets and sintered NdFeB magnets, bonded NdFeB magnets require higher magnetization energy to achieve saturation magnetization. If the applied magnetic field is lower than the saturation magnetization The required magnetic field will cause the unsaturated magnetization of the bonded NdFeB magnets.
The picture below shows the external magnetic field required for ferrite, bonded NdFeB, and sintered NdFeB to achieve saturation magnetization
What are the causes of unsaturated magnetized bonded NdFeB?
1. The current of the magnetizing system is insufficient
2. The magnetizer is not suitable
3. The magnetizing fixture is not suitable
What are the effects of unsaturated bonded neodymium magnets?
The possibility of magnet demagnetization increases, the no-load speed increases, the current increases, the stall torque decreases, the maximum output power decreases, and the efficiency decreases.
How can it be considered saturation magnetization?
A magnet is considered saturated when increasing magnetization energy fails to produce a significant change in magnet performance (usually less than 2%).
Note: The magnetization energy required for saturation magnetization bonded neodymium magnets is determined by the magnet size, density, material and required magnetization method.
More about bonded neodymium magnets;
This is a very small rectangular ferrite block magnet, measuring 2.45 mm in length and 1 mm in both width and height. It is magnetised along its length and is barely noticeable when held in the hand....
7.4x6x5mm Ferrite Small Block Magnet Introduction，Material: Hard Ferrite (Ceramic)，Shape: Block / Rectangle / Bar，Coating: No Coating，Grade (Chinese Stardard): Y30，Operating temperature: -40°C to 250°C，Delivery time: 7-15 days，Magnetization direction: thickness....
U-shaped neodymium magnets are a type of high-performance permanent magnet material with a structure resembling the letter ‘U’. Manufactured from sintered neodymium-iron-boron, they are characterised by high magnetic energy product....
This is a radial 4-pole ring (Hollow cylinder) magnet, the material is bonded NdFeB, with high magnetic performance, the size is 16mm outer diameter, inner hole 5mm, height 20mm, surface gray epoxy treatment, suitable for water pump motor...
This product is a 4-pole ring magnet, injection-molded ferrite material, the sample size is 22mm outer diameter, 7mm inner diameter, 4mm thickness, 2 N poles and 2 S poles, mainly used for push rod motors, magnetic induction devices, encoders, etc.,...
This is a radial 2 pole circular magnet designed specifically for magnetic encoder chips. It is made of sintered neodymium-iron-boron with N35 grade performance and is suitable for standard environments....
This product is a multi pole magnetic ring with an inner diameter of 1.5mm. The material is injection molded ferrite. It adopts axial multi pole magnetization and is mainly used for DC motors. If you have a sample of similar injection molded magnetic products, please contact us for quotation....
This is a very small size rectangular block magnet with galvanized surface, 3mm length, 1.5mm width and height, with very fine tolerance, magnetized by lengthwise direction, mainly used in precision electronics, instrumentation, please contact us if you need to buy....