0769-23388351
Toggle Navigation
Hall induction magnet, the magnet used in conjunction with the hall, today I will introduce to you which side of the hall sensor induction magnet is the question that netizens care about.
Hall effect sensors are activated by a magnetic field, and in many applications the device can be operated by a single permanent magnet attached to a moving shaft or device, there are many different types of magnet movements such as "front", "side", "push-pull" Or "push-push" and other induction motions, which I see a lot are generally the end face or radial face of the induction magnet, as shown in the figure below.
For example, frontal detection requires the magnetic field to be perpendicular to the Hall-effect sensing device and, for detection, to approach the sensor directly towards the active surface.
Side detection This requires moving the magnet across the surface of the Hall element in a lateral motion.
The above is a brief introduction to which side of the Hall sensor induction magnet. If you need to buy a Hall induction magnet, please contact the Courage magnet manufacturer, which can provide magnet materials such as NdFeB, ferrite, and samarium cobalt.
Related Hall sensor magnets;
Ultra Small Ferrite Block Magnets For Hall Sensor 3.8x0.8x2mm
This is a very small rectangular ferrite block magnet, measuring 2.45 mm in length and 1 mm in both width and height. It is magnetised along its length and is barely noticeable when held in the hand....
7.4x6x5mm Ferrite Small Block Magnet Introduction，Material: Hard Ferrite (Ceramic)，Shape: Block / Rectangle / Bar，Coating: No Coating，Grade (Chinese Stardard): Y30，Operating temperature: -40°C to 250°C，Delivery time: 7-15 days，Magnetization direction: thickness....
U-shaped neodymium magnets are a type of high-performance permanent magnet material with a structure resembling the letter ‘U’. Manufactured from sintered neodymium-iron-boron, they are characterised by high magnetic energy product....
This is a radial 4-pole ring (Hollow cylinder) magnet, the material is bonded NdFeB, with high magnetic performance, the size is 16mm outer diameter, inner hole 5mm, height 20mm, surface gray epoxy treatment, suitable for water pump motor...
This product is a 4-pole ring magnet, injection-molded ferrite material, the sample size is 22mm outer diameter, 7mm inner diameter, 4mm thickness, 2 N poles and 2 S poles, mainly used for push rod motors, magnetic induction devices, encoders, etc.,...
This is a radial 2 pole circular magnet designed specifically for magnetic encoder chips. It is made of sintered neodymium-iron-boron with N35 grade performance and is suitable for standard environments....
This product is a multi pole magnetic ring with an inner diameter of 1.5mm. The material is injection molded ferrite. It adopts axial multi pole magnetization and is mainly used for DC motors. If you have a sample of similar injection molded magnetic products, please contact us for quotation....
This is a very small size rectangular block magnet with galvanized surface, 3mm length, 1.5mm width and height, with very fine tolerance, magnetized by lengthwise direction, mainly used in precision electronics, instrumentation, please contact us if you need to buy....