0769-23388351
Toggle Navigation
Can the have magnetic NdFeB strong magnet be magnetized again after demagnetization at high temperature? Can the original axial magnetization be changed into radial magnetization? This is a common magnet problem. Xiao Fu has also received many similar problems. Today, I specially edit this article to tell you.
Can magnetically charged NdFeB magnets be demagnetized and then magnetized?
Sure. Nd-Fe-B can be demagnetized after magnetization or re magnetized after demagnetization, but its magnetic properties will decline. The magnetic force of the magnet is not determined by the magnetizing machine, but determined by the sintering and forming of the blank. This involves the problem of rare earth ratio, and the magnetized magnet products are not suitable for further machining.
Can the axially magnetized magnet be radially magnetized by the magnet manufacturer?
This problem has been encountered many times by Xiaobian. The magnetizing direction of sintered NdFeB is determined during the production of raw materials. It is axial magnetization or axial magnetization. Its magnetizing direction cannot be changed. You need to explain the required magnetization direction to the magnet manufacturer.
The above is an introduction on whether it is feasible to change the magnetization method of the magnet. If you have any questions about the magnetization of the magnet, please leave a message online or call our company for consultation.
More magnet magnetization methods are introduced;
Detailed introduction of magnet axial magnetization and radial magnetization
Schematic Diagram of Permanent Magnet Magnetization Direction
This is a very small rectangular ferrite block magnet, measuring 2.45 mm in length and 1 mm in both width and height. It is magnetised along its length and is barely noticeable when held in the hand....
7.4x6x5mm Ferrite Small Block Magnet Introduction，Material: Hard Ferrite (Ceramic)，Shape: Block / Rectangle / Bar，Coating: No Coating，Grade (Chinese Stardard): Y30，Operating temperature: -40°C to 250°C，Delivery time: 7-15 days，Magnetization direction: thickness....
U-shaped neodymium magnets are a type of high-performance permanent magnet material with a structure resembling the letter ‘U’. Manufactured from sintered neodymium-iron-boron, they are characterised by high magnetic energy product....
This is a radial 4-pole ring (Hollow cylinder) magnet, the material is bonded NdFeB, with high magnetic performance, the size is 16mm outer diameter, inner hole 5mm, height 20mm, surface gray epoxy treatment, suitable for water pump motor...
This product is a 4-pole ring magnet, injection-molded ferrite material, the sample size is 22mm outer diameter, 7mm inner diameter, 4mm thickness, 2 N poles and 2 S poles, mainly used for push rod motors, magnetic induction devices, encoders, etc.,...
This is a radial 2 pole circular magnet designed specifically for magnetic encoder chips. It is made of sintered neodymium-iron-boron with N35 grade performance and is suitable for standard environments....
This product is a multi pole magnetic ring with an inner diameter of 1.5mm. The material is injection molded ferrite. It adopts axial multi pole magnetization and is mainly used for DC motors. If you have a sample of similar injection molded magnetic products, please contact us for quotation....
This is a very small size rectangular block magnet with galvanized surface, 3mm length, 1.5mm width and height, with very fine tolerance, magnetized by lengthwise direction, mainly used in precision electronics, instrumentation, please contact us if you need to buy....