0769-23388351
Toggle Navigation
A few questions that people often ask about magnet mold opening. Can a magnet open mold? Which magnets must be moulded? How much is the mold fee? As well as a time to open the mold, today these questions will be answered one by one for you.
1. Can the magnet be moulded?
Yes, but the current mainstream sintered NdFeB strong magnets do not need to open molds, but use block materials for processing, even if it is a special shape, you don't need to open molds, and ferrites can be made in the range of conditions. The following can be opened.
2. Which magnets must be made of molds?
This has been introduced before, click "What are the magnets that require mold to produce? "Check.
3. How much is the magnet mold fee?
This depends on the size and difficulty of the mold. Generally, the cost of the mold is 20,000-20,000-30,000. The cost of the heterosexual mold such as sintered ferrite is much higher than that of the same sex.
4. How long does it take for the magnet to open the mold?
This requires specific communication with the magnet manufacturer, usually around 15-45 days.
The above has introduced several common questions about magnet mold opening that everyone often pays attention to. Customers who are interested in mold opening are welcome to inquire (there are many specifications, maybe there is what you are looking for).
Magnets that need to be processed by molds;
This is a very small rectangular ferrite block magnet, measuring 2.45 mm in length and 1 mm in both width and height. It is magnetised along its length and is barely noticeable when held in the hand....
7.4x6x5mm Ferrite Small Block Magnet Introduction，Material: Hard Ferrite (Ceramic)，Shape: Block / Rectangle / Bar，Coating: No Coating，Grade (Chinese Stardard): Y30，Operating temperature: -40°C to 250°C，Delivery time: 7-15 days，Magnetization direction: thickness....
U-shaped neodymium magnets are a type of high-performance permanent magnet material with a structure resembling the letter ‘U’. Manufactured from sintered neodymium-iron-boron, they are characterised by high magnetic energy product....
This is a radial 4-pole ring (Hollow cylinder) magnet, the material is bonded NdFeB, with high magnetic performance, the size is 16mm outer diameter, inner hole 5mm, height 20mm, surface gray epoxy treatment, suitable for water pump motor...
This product is a 4-pole ring magnet, injection-molded ferrite material, the sample size is 22mm outer diameter, 7mm inner diameter, 4mm thickness, 2 N poles and 2 S poles, mainly used for push rod motors, magnetic induction devices, encoders, etc.,...
This is a radial 2 pole circular magnet designed specifically for magnetic encoder chips. It is made of sintered neodymium-iron-boron with N35 grade performance and is suitable for standard environments....
This product is a multi pole magnetic ring with an inner diameter of 1.5mm. The material is injection molded ferrite. It adopts axial multi pole magnetization and is mainly used for DC motors. If you have a sample of similar injection molded magnetic products, please contact us for quotation....
This is a very small size rectangular block magnet with galvanized surface, 3mm length, 1.5mm width and height, with very fine tolerance, magnetized by lengthwise direction, mainly used in precision electronics, instrumentation, please contact us if you need to buy....