0769-23388351
Toggle Navigation
Ferrite magnets started in the 1950s and are widely used because they are the most economical, have good magnetic properties, and are environmentally stable. According to the raw material, it is divided into dam-based ferrite and high-coercivity strontium-based ferrite, but in recent years, barium-based ferrite has been discontinued due to environmental and health reasons.
Our company can produce both anisotropic and isotropic ferrites, and anisotropic products are 3 times higher than isotropic magnetic energy products. After incoming inspection, raw materials (mainly iron oxide, strontium carbonate) will be weighed, batched, pre-fired and then ball milled. For homosexual products, the raw materials are ground into powder and then pressed. There are two ways to produce heterosexual products: dry pressing and wet pressing. Sintering, processing and cleaning, and magnetization after molding. The magnet surface can be machined, marked or plated according to customer requirements.
Relevant pitted magnets;
Ferrite grade, sintered ferrite magnetic property parameter table
NdFeB magnet grade, Sintered neodymium magnet performance grade parameter table
Neodymium(Ndfeb) Magnet Material Safety Data Sheet
Sintered Ferrite Material Safety Data Sheet Pdf
Magnetic properties grade parameters of smco rare earth magnets
This product is a square ceramic magnet, made of sintered ferrite anisotropy, with low remanence, low recovery magnetic permeability, and strong anti-demagnetization ability. 12mm, suitable for fitness equipment, massager, magnetic control machine, air pump, if you are interested in this product, please contact....
You are now viewing this is a super small (tiny) size ferrite block magnet sample, high performance grade Y30, magnet length 2.45mm, width and thickness are 1mm, magnetization direction along the length....
This product is a variety of isotropic ferrite (Y10) rotor magnets ring, which are processed and manufactured by the Chinese permanent magnet supplier Courage Magnet. The inner aperture size of the magnet is 5.4mm, and the surface is smooth and free of defects. It can be magnetized according to the number of magnetic poles required by customers, such as radial 2, 4, 6, and 8 poles...
This product is a float switch magnet, a float ring magnet, and the material is ferrite. Drinking system, etc.), industrial equipment (such as: air oil compressor, air cooler, drain, lubricating oil system), gardening equipment, medical equipment, beauty salon equipment, aquaculture and industrial water purification, sewage treatment system, automatic door control system, Automotive and other industries....
This product is a cut ferrite square magnet, rectangular, Y30BH grade, side magnetized, mainly used for door sensor alarms, dry yellow tubes, the size is 25mm in length, 9mm in width, and 7mm in thickness. If you need this sample or want To understand the price, please send us an inquiry....
Note that this is not a NdFeB magnet. From the outside, it is indeed the same as a neodymium magnet, but in fact it is made of ferrite with a coating on the surface for magnetic therapy, such as knee pads, waist pads, neck pads, shoes, Pillow can be used, the picture below shows its magnetic force, the highest is about 800 Gauss....
This product is a ferrite magnet with a counterbore. The difference from ferrite ring magnets is the hole in the middle. The counterbore is mainly used with screws. Due to magnetism and processing problems, most of them choose neodymium iron. Boron counterbore instead, if you need to buy this counterbore ceramic magnet, welcome to communicate with us....
This product is a square ceramic ferrite magnet, magnetic grade is Y30, size is length 50mm, width 50mm, thickness 25mm, thickness direction magnetization. The place of production is Dongguan, China. It is mainly used for industry, machinery and equipment, and personal experiments, if you need it Please contact us to purchase this magnet, the minimum order quantity is 10 pcs....