0769-23388351
Toggle Navigation
General Physical Properties of Alnico magnets;
Manufactured by casting or powder metallurgy
Alloy consisting of AI-Ni-Fe-Co
Very hard and brittle
Low demagnetization resistance
Excellent temperature stability
Good machinability
Average magnetic properties
Casting And Sintering Alnico Magnets Physical Properties | |||
Property | Units | Value Sintered Alnico | Value Cast Alnico |
Vickers Hardness | Hv | 440 | 440-620 |
Density | g/cm3 | 6.8 – 7.0 | 6.9 – 7.3 |
Curie Temp TC | °C | 810 – 860 | 740 – 860 |
Curie Temp TF | °F | 1,400 – 1,580 | 1,460 – 1,580 |
Specific Resistance | μΩ⋅Cm | 50- 70 | 45 – 75 |
Bending Strength | kN/mm2 | 0.35 – 0.76 | 0.05 – 0.31 |
Tensile Strength | kN/mm2 | 0.35- 0.45 | 0.02 – 0.15 |
Thermal Expansion | °C-1 | +11.0 to +12.4 x10-6 | +11.0 to +13.0 x10-6 |
The listed values are approximate and should be used as a reference. Any magnetic or physical characteristics should be substantiated before selecting a magnet material. | |||
Product Direct Category;
The following article may be helpful;
This is a very small rectangular ferrite block magnet, measuring 2.45 mm in length and 1 mm in both width and height. It is magnetised along its length and is barely noticeable when held in the hand....
7.4x6x5mm Ferrite Small Block Magnet Introduction，Material: Hard Ferrite (Ceramic)，Shape: Block / Rectangle / Bar，Coating: No Coating，Grade (Chinese Stardard): Y30，Operating temperature: -40°C to 250°C，Delivery time: 7-15 days，Magnetization direction: thickness....
U-shaped neodymium magnets are a type of high-performance permanent magnet material with a structure resembling the letter ‘U’. Manufactured from sintered neodymium-iron-boron, they are characterised by high magnetic energy product....
This is a radial 4-pole ring (Hollow cylinder) magnet, the material is bonded NdFeB, with high magnetic performance, the size is 16mm outer diameter, inner hole 5mm, height 20mm, surface gray epoxy treatment, suitable for water pump motor...
This product is a 4-pole ring magnet, injection-molded ferrite material, the sample size is 22mm outer diameter, 7mm inner diameter, 4mm thickness, 2 N poles and 2 S poles, mainly used for push rod motors, magnetic induction devices, encoders, etc.,...
This is a radial 2 pole circular magnet designed specifically for magnetic encoder chips. It is made of sintered neodymium-iron-boron with N35 grade performance and is suitable for standard environments....
This product is a multi pole magnetic ring with an inner diameter of 1.5mm. The material is injection molded ferrite. It adopts axial multi pole magnetization and is mainly used for DC motors. If you have a sample of similar injection molded magnetic products, please contact us for quotation....
This is a very small size rectangular block magnet with galvanized surface, 3mm length, 1.5mm width and height, with very fine tolerance, magnetized by lengthwise direction, mainly used in precision electronics, instrumentation, please contact us if you need to buy....